First Principles calculation of Half metallic proprieties of QCrAs (Q=Hf, Ti and Zr)
Keywords:
Half Heusler, Half metallic gap, Electronic band structure, Mechanical propertiesAbstract
The structural, electrical, magnetic, mechanical, and thermodynamic properties of some novel half-Heusler alloys QCrAs(Q=Hf, Ti and Zr) are investigated using first principles calculations. The results show that the three half Heusler alloys are half metals and they can find application in spintronics industries. They possess magnetic moment of 3\mu_B. The mechanical properties shows that they are mechanically stable. The B/G ratio of the three half-Heusler alloys show that they are ductile in nature and the Poisson’s ratio reveal that the plasticity of TiCrAs and ZrCrAs are higher than that of HfCrAs. The Debye temperature and average sound velocity of ZrCrAs is observed to be higher than the other two alloys. This implies that the thermal conductivity of ZrCrAs is the highest.
Published
How to Cite
Issue
Section
Copyright (c) 2023 M. I. Babalola, B. E. Iyorzor, S. O. Ebuwa

This work is licensed under a Creative Commons Attribution 4.0 International License.
How to Cite
Similar Articles
- A. F. Afolabi, S. S. Oluyamo, I. A. Fuwape, Synthetic Characterization of Cellulose from Moringa oleifera seeds and Potential Application in Water Purification , Journal of the Nigerian Society of Physical Sciences: Volume 3, Issue 3, August 2021
- Thirumalai A, Muthunagai K, Ritu Agarwal, Pre-functions and Extended pre-functions of Complex Variables , Journal of the Nigerian Society of Physical Sciences: Volume 5, Issue 2, May 2023
- Ayomide Hassan Labulo, Elijah Temitope Adesuji, Charles Ojiefoh Oseghale, Elias Emeka Elemike, Adamu Usman, Akinola Kehinde Akinola, Enock Olugbenga Dare, Corrigendum to "Effect of benzophenone on the physicochemical properties of N-CNTs synthesized from 1-ferrocenylmethyl (2-methylimidazole) catalyst" [J. Nig. Soc. Phys. Sci. 2 (2020) 205-217] , Journal of the Nigerian Society of Physical Sciences: Volume 3, Issue 2, May 2021
- Yusuf Olanrewaju Saheed, Mufutau Abiodun Salawu, Aderemi Babatunde Alabi, Mechanical Evaluation and Minerals Phases Identification of Fine and Coarse Okelele Block Clay Composites for Furnace Lining Application , Journal of the Nigerian Society of Physical Sciences: Volume 4, Issue 1, February 2022
- D. D. Bwede, R. A. Wuana, G. O. Egah, A. U. Itodo, E. Ogah, E. A. Yerima, A. I. Ibrahim, Characterization and Evaluation of Human Health Risk of Heavy Metals in Tin Mine Tailings in Selected Area of Plateau State, Nigeria , Journal of the Nigerian Society of Physical Sciences: Volume 3, Issue 4, November 2021
- Terver Daniel, F. Eriba-Idoko, J. O. Tsor, S. T. Kungur, E. O. Enokela, F. Gbaorun, E. C. Hemba, A. A. McAsule, N. S. Akiiga, P. O. Ushie, Effects of Repeated Frying on Physical Properties of Cooking Oil obtained from Local Markets in Makurdi Metropolis, Benue State, Nigeria. , Journal of the Nigerian Society of Physical Sciences: Volume 3, Issue 4, November 2021
- Victor Oboni Atabo, Solomon Ortwer Adee, A New Special 15-Step Block Method for Solving General Fourth Order Ordinary Differential Equations , Journal of the Nigerian Society of Physical Sciences: Volume 3, Issue 4, November 2021
- B. M. Dyavappa, Higher order Motional Resonances Spectra of electrons with Non-linear Axial Oscillations in Quadrupole Penning trap , Journal of the Nigerian Society of Physical Sciences: Volume 4, Issue 1, February 2022
- A. Y. Fasasi, E. Ajenifuja, E. Osagie, L. O. Animasaun, A. E. Adeoye, E. I. Obiajunwa, Optical, Dielectric and Optoelectronic Properties of Spray Deposited Cu-doped Fe2O3 Thin Films , Journal of the Nigerian Society of Physical Sciences: Volume 5, Issue 3, August 2023
- Suha Ibrahim Salih Al-Ali, Zaidun Naji Abudi, Mohammed Nsaif Abbas, Modelling and Simulation for the use of Natural Waste to Purified Contaminated Heavy Metals , Journal of the Nigerian Society of Physical Sciences: Volume 5, Issue 1, February 2023
You may also start an advanced similarity search for this article.

